Toro Recycler 20013 Operator's Manual
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. 20013
  6. Operator's manual
Toro Recycler 20013 Operator's Manual

Toro Recycler 20013 Operator's Manual

Hide thumbs Also See for Recycler 20013:
Table of Contents

Advertisement

Quick Links

Download this manual
22 Recycler
Lawn Mower
Model No. 20013—Serial No. 220000001 and Up
Introduction
Read this manual carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for
operating the product properly and safely.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The
illustration below identifies the location of the model
and serial numbers on the product. Write the
numbers in the space provided below:
Model #:
Serial #:
This manual identifies potential hazards and has
safety messages identified by the following words:
Danger signals an extreme hazard that will
cause serious injury or death if you do not follow
the recommended precautions.
Warning signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
Caution signals a hazard that may cause minor
or moderate injury if you do not follow the
recommended precautions.
This manual uses two other words to highlight
information. Important: calls attention to special
mechanical information and Note: emphasizes
general information worthy of special attention.
Warning
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects, or other reproductive
harm.
Important: This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate this
engine on any forest-covered, brush-covered or
grass-covered land. Other states or federal areas
may have similar laws.
Printed in USA
Original Instructions (EN)
This spark ignition system complies with Canadian
ICES-002.
The enclosed Engine Owner's Manual is supplied for
information regarding The U.S. Environmental
Protection Agency (EPA) and the California Emission
Control Regulation of emission systems, maintenance
and warranty. Replacements may be ordered through
the engine manufacturer.
Safety
This lawn mower meets or exceeds the CPSC blade
safety requirements for walk-behind rotary lawn
mowers in effect at the time of production.
Read and understand the contents of this manual
before the engine is ever started.
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol
m-5607
to avoid possible injury or death.
Improperly using or maintaining this mower
could result in injury or death. To reduce this
potential, comply with the following safety
instructions.
The following instructions have been adapted from
the ANSI/OPEI standard B71.1—1998.
General Operation
Read, understand, and follow all instructions on
the machine and in the manual. Be thoroughly
familiar with the controls and the proper use of
the mower before starting.
Do not put hands or feet near or under rotating
parts. Keep clear of the discharge opening at all
times.
Only allow responsible individuals, who are
familiar with the instructions, to operate the
mower.
Clear the area of objects such as rocks, toys,
wire, bones, sticks etc., which could be picked up
and thrown by the blade.
Be sure the area is clear of other people before
mowing. Stop mower if anyone enters the area.
Do not operate the mower when barefoot or
wearing open sandals. Always wear substantial
foot wear.
3328-274
Form No. 3328-274
Operator's Manual
2002 by The Toro Company
All Rights Reserved

Advertisement

Table of Contents
loading

Related Manuals for Toro Recycler 20013

Summary of Contents for Toro Recycler 20013

  • Page 1 Whenever you need service, genuine Toro parts, or the engine manufacturer. additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready. The Safety illustration below identifies the location of the model and serial numbers on the product.

  • Page 2: Slope Operation

    See the Toro instructions for proper operation and Keep children out of the mowing area and under installation of accessories. Only use Toro the watchful care of a responsible adult accessories.

  • Page 3: Safety/Instruction Decals

    Frequently check components and replace with genuine Toro parts, when necessary. Safety/Instruction Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. 104-7909 1.

  • Page 4: Product Overview

    1. Carefully move the upper handle forward until the Product Overview handle halves are in line and nest together as shown. m-5602b 2. Tighten the handle knobs. m-5630a 1. Cutting height lever 5. Fuel tank cap m-5620 2. Oil fill/Dipstick 6.

  • Page 5: Before Operating

    Before Operating Danger Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a vehicle or on an object. Fill the tank outdoors when the engine is cold.

  • Page 6: Adjusting The Handle Height

    Adjusting the Handle Height To adjust the handle height, squeeze the bottom of the handle halves together (as shown) and change the handle holes in which the pins (A) are mounted, as follows: Raise the handle m-5614 using hole (B). Lower the handle m-5612 using hole (C).

  • Page 7: Operation

    Using the Self-propel Drive Operation To operate the self-propel drive, simply walk with your Starting the Engine hands on the upper handle and your elbows at your sides, and the mower will automatically keep pace 1. Firmly push in the with you.

  • Page 8: Cutting Grass

    Replace the blade when necessary with an If the finished lawn appearance is unsatisfactory, try original Toro replacement blade. one or more of the following: Replace the blade or have it sharpened. Cutting Grass Walk at a slower pace while mowing.

  • Page 9: Preparing For Maintenance

    Preparing for Maintenance 1. Remove the dipstick. 1. Stop the engine and wait for all moving parts to stop. 2. Disconnect the spark plug wire from the m-5604 spark plug and hook it 2. Tip the mower onto onto the retaining post the right side to drain (A) before performing the used oil out through...

  • Page 10: Replacing The Blade

    Replacing the Blade Curved or Captive Washer For the curved or captive washer (A), torque the Important: You will need a torque wrench to blade bolt to 60 ft-lb (82 N m). install the blade properly. If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer.

  • Page 11: Cleaning The Mower

    Cleaning the Mower Folding the Handle 1. With the engine running on a flat paved Warning surface, spray a stream of water in front of the Folding or unfolding the handle improperly can right rear wheel. damage the cables, causing an unsafe operating 1093 condition.
  • Page 12 Instructions for Obtaining Warranty Service If you think that your Toro Product contains a defect in materials or workmanship, or if a normal, able-bodied adult can no longer start your product’s engine in one or two pulls, follow this procedure: 1.

Table of Contents