Adjusting The Self-Propel Drive Cable; Cleaning Under The Belt Cover; Replacing The Spark Plug - Toro Recycler 20010 Operator's Manual

Adjusting the Serf-propel Drive
Cable
Whenever you change the handle height, install a new
self-propel drive cable, or the traction drive belt slips,
adjust the self-propel drive cable.
You adjust the self-propel drive cable on the handle by
moving the cable .jacket held by the cable support.
1. Loosen the nut on the cable support (Fig. 27).
2
5
Figure 27
1. 1 to 11/2 in. (25 to 38 mm) 4. Cable support
2. Self-propel drive bail 5. Nut
3. Cable jacket
1063
2. Hold the self-propel drive bail I to 11/2 in.
(25 to 38 nml) from the handle (Fig. 27).
3. Pull the cable .jacket down (away from the bait).
4. Tighten the nut on the cable support.
5. Release the bait and ensure that the cable is loose.
Note: The cable nmst be loose when the self-propel drive
bail is in the disengaged position to prevent the lawn
mower from creeping forward when you disengage the
bail.
Cleaning under the Belt Cover
Keep the area under the belt cover free of debris.
1. Stop the engine and wait for all moving parts to stop.
2. Remove the bolts that secure the belt cover to the lawn
mower housing (Fig. 28).
1.
Figure 28
Belt cover 2. Bolt
1666
3. Lift offthe cover and brush out all the debris from the
belt area.
4. Install the belt cover.
Replacing the Spark Plug
Check the spark plug after every 25 operating hours. Use a
('hampiol_ RJ19LM spark plug or equivalent.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 29).
1
1002
Figure 29
1. Spark plug wire
3. Clean around the spark plug.
4. Remove the spark plug from the cylinder head.
IMPORTANT: Replace a cracked, fouled, or dirty
spark plug. Do not clean the electrodes because grit
entering the cylinder can cause engine damage.
Set the gap on the new plug to 0.030 in. (0.76 ruru)
(Fig. 30).
Figure 30
1. 0.030in. (.76 mm)
986
6. Install the spark plug and the gasket seal.
18