Table of Contents
Advertisement
OMPLTV32.book
Page 3 Friday, June 10, 2005 8:48 AM
the Display
The display requires a stable, level, and clean surface near a power outlet,
10 cm (4") away from
walls or other large objects. The rear ventilation
grid should be unobstructed,
and the display
should not be exposed to water or heat. Before setting
up the display, prepare such a space.
To set up the display:
1.
Remove
the power
cord and DC power
adapter
from the
accessories
box.
Insert the appropriate
end of the cord into the power
connector
on the DC power adapter, then insert the
other end into a free power outlet.
The blue light on the DC power adapter should come on.
If it doesn't, check that the cord is securely connected
and that the power outlet works properly.
Insert the DC power adapter's cord into the power connector
on the bottom
of the display.
Note:
Make sure you plug the power connector
into the
display with the arrow on top. Failure to do so will
cause a short circuit.
Connecting
to a TV Signal
Source
A TV signal
may come
from
a cable
box, satellite
receiver,
antenna, or similar device.
To connect
a TV signal
source
to the display:
1.
Connect
a coax cable
between
the antenna
jack on the
bottom
of the display
and the signal
source (that
is, the
cable
box, satellite
receiver,
or antenna).
Note:
If you would like to be able to record the TV signal with a VCR or similar device, connect
the signal source to the input of the recording device with one cable, then connect the
output of the recording device to the antenna jack on the display with another cable.
Hide quick links:
Advertisement
Table of Contents
