Table of Contents
Advertisement
OMPLTV32.book
Page 5 ICriday, June 10, 2005 8:48 AM
Output
Devices
that have composite
video
have S-Video outputs.
S-Video uses
four-wire
cable to transmit
video
information.
Two of the wires
are used to
transmit video. Because it splits the video signal
into two components,
S-Video generally
provides
higher quality than composite video, but lower
quality
than
component
video
(see below).
Note:
The composite video and S-Video inputs
share an audio
input.
Note:
The pins used in S-Video connectors are
somewhat
fragile.
Take care to avoid
bending the pins, as a bent or broken pin
can cause loss of color
information
or
total signal loss.
To connect an S-Video
source to the display:
....
1.
Remove the connector
panel cover.
2.
Using an S-Video cable, connect the S-Video
output
on the source device to the S-Video
jack on the connector
panel.
3.
Using two RCA cables, connect the right (red)
and left (white) audio outputs
on the source
to the corresponding
AUDIO-IN jacks next to
the VIDEO-IN jack.
4.
Replace the connector
panel cover.
Setting
Up the Display
1.>
Hide quick links:
Advertisement
Table of Contents
