Connecting To Component Video (Interlaced) Output Devices; Connecting To A Pc - PROTRON PLTV-32 User Manual

OMPLTV32.book Page 7 ICriday, June 10, 2005 8:48 AM
Setting Up the Display
Video (Interlaced) Output Devices
component video uses three signals
Cb, and Cr. Use this procedure only for
video (video formats 480i, 525i, 720i,
and so on). See the previous section for
information on connecting progressive scan
signals to the display.
Note: The two component video inputs (RCA
and D4) share an audio input.
To connect an interlaced component video
source to the display:
1. Remove the connector panel cover.
2. Using three RCA cables, connect the three
component video outputs (Y, Cb, and Cr) to
the corresponding jacks on the connector
panel.
3. Using two RCA cables, connect the right (red)
and left (white) audio outputs on the source
to the corresponding AUDIO-IN jacks next to
the component inputs on the connector
panel.
4. Replace the connector panel coven
Connecting to a PC
Your display can be used as a computer monitor for any computer with a VGA or DVl video
output. In addition, the computer's audio output can be connected to the display and played
through the display's speakers.
To
1.
connect a PC to the display:
Set the video resolution on the computer to 1280 x 1024 or less before connecting to the
display.
In Windows, right-click on the desktop and select
Properties to bring up the Display Properties window.
Select the Settings tab. Adjust the Screen resolution
as needed, select Apply, then select OK.