Finishing Material - Heat & Glo ST-36TR-IPI Owner's Manual

D. Finishing Material
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed. For an
inside fi t there is an available template to assist with siz-
ing the fi nishing material.
ST-36TR-IPI
DOOR FIT
Aero Inside
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Valencia
Inside
Overlap
Galleria
Inside
PIER-36TR-IPI
DOOR FIT
Aero Inside
Chateau Inside
Arcadia Inside

FINISHING MATERIAL

Stop fi nishing material fl ush with opening.
Figure 13.18 Folio Door and Aero
FRONT FACE OF FIREPLACE
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 13.19 Overlap Fit Door
FINISH MATERIAL
MAXIMUM SEE FIGURE
THICKNESS
Any 13.18
Any 13.18
1 inch 13.19
Any 13.20
1 inch 13.19
1 inch - 2 inch 13.21
1 inch 13.19
Any 13.20
1 inch 13.19
Any 13.20
1 inch 13.19
1 inch - 2 inch 13.21
FINISH MATERIAL
MAXIMUM SEE FIGURE
THICKNESS
Any 13.22
Any 13.22
Any 13.22
DOOR
FINISHING MATERIAL
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. G • 3/13
FINISHING
MATERIAL
DOOR
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
33-3/4 in.
(Inside door height)
37 in.
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
Finishing materials over 1 inch thick.
Figure 13.20 Inside Fit Door
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
DOORS
37-1/4 IN.
Finishing material between 1 and 2 inches thick.
Figure 13.21 Operable Hinge Door
FINISHING
MATERIAL
37 in.
34 in.
FINISHING
MATERIAL
61