Installer Guide; Getting Started; Typical Appliance System - Heat & Glo ST-36TR-IPI Owner's Manual

4 4

Getting Started

A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product may vary from pictures in manual
HORIZONTAL
TERMINATION CAP
(SECTION 10.M )
Note: Dual venting configurations
ARE NOT allowed. Appliance MUST
be vented EITHER vertically OR
horizontally.
Figure 4.1 Typical System
16

Installer Guide

FRAMING/HEADER
(SECTION 5.B)
GAS LINE
(SECTION 11.C)
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. G • 3/13
NON-COMBUSTIBLE ROOF FLASHING
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 10.G)
HEARTH EXTENSION
SURROUND
VERTICAL TERMINATION CAP
(SECTION 10.J)
VENT PIPE PENETRATES ROOF
PREFERABLY WITHOUT AFFECTING
ROOF RAFTERS (SECTION 8.C )
ATTIC INSULATION SHIELD (NOT
SHOWN) MUST BE USED HERE
TO KEEP INSULATION AWAY
FROM VENT PIPE IF ATTIC IS
INSULATED (SECTION 8.D )
VENT PIPE (SECTION 9 and 10)
FRAMING HEADED OFF
IN CEILING JOISTS
(SECTION 8.C)
CEILING FIRESTOP
ON FLOOR OF ATTIC
(SECTION 8.C)
WALL SWITCH
SECTION 12.E.
MANTEL AND
MANTEL LEG
(SECTION 5.D)
STORM COLLAR
(SECTION 10.H)