Installation Of Fireplace; Things To Consider; Position The Fireplace; Place Protective Metal Hearth Strips - Heatilator BIR50-B Owner's Manual

Installation and operation
Hide thumbs Also See for BIR50-B:
Table of Contents

Advertisement

7

Installation of Fireplace

CAUTION! Risk of Cuts/Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
A. Things to Consider
Location(s) of outside air kit(s)
Gas line piping
B. Position the Fireplace
Place the fireplace on a continuous flat surface.
Follow framing instructions in Section 6.
WARNING! Risk of Fire! Prevent contact with sagging,
loose insulation.
• DO NOT install against vapor barriers or exposed
insulation.
• Secure insulation and vapor barriers.
• Provide minimum air space clearances at the sides
and back of the fireplace assembly as outlined in
Section 6.
C. Place Protective Metal Hearth Strips
WARNING! Risk of Fire! Metal hearth strips MUST be
installed. DO NOT cover metal strips with combustible ma-
terials. Sparks or embers may ignite flooring.
Refer to Figures 7.1 and 7.2.
Locate the two metal hearth strips measuring approximately
26 in. x 4 in. (660 mm x 102 mm) included with this
fireplace.
Slide each metal strip 2 in. (51 mm) under front edge of
fireplace.
Overlap strips in the middle of fireplace opening by 1 in
(25 mm) minimum..
Metal strips must extend beyond the front and sides of the
fireplace opening by at least 2 in. (51 mm).
Protect the front of a platform elevated above the hearth
extension with metal strips (not included with fireplace)
per Figure 7.2. See Section 12 for hearth extension
instructions.
D. Level Fireplace
Level fireplace side-to-side and front-to-back.
Shim with non-combustible material as necessary.
Secure fireplace to framing with nailing flanges with a
minimum of two fasteners per nailing flange.
Check fireplace opening for square to ensure proper fit of
glass doors. Measure diagonals of fireplace opening to
make sure they are equal.
Heatilator • Birmingham BIR50-B • 4059-682D• 9/12
Protective metal strips are placed 2 in. (51 mm) under the
front of the fireplace and must extend beyond the front
and sides of fireplace opening by 2 in. (51 mm).
Figure 7.1
Position the Protective Metal Hearth Strips
Top piece must overlap
Raised Platform
2 in.
(51 mm)
2 in.
(51 mm)
Figure 7.2
Protect the Front of an Elevated Platform
1 in. (25 mm)
overlap
bottom piece
1 in. (25 mm) min.
overlap
Floor
21

Advertisement

Table of Contents
loading

Table of Contents