Table of Contents
Advertisement
ASSEMBLING THE MOWER BEFORE FIRST USE
Delivery Checklist
Remove the mower from the packaging and check that
the following items have been supplied correctly. If any
items are missing, contact your local Hayter dealer.
1. Motor Handbook.
5. Warranty Reg Card.
2. Grassbag Frame.
6. Supply Cable.
3. Grassbag Top Cover.
7. Parts list/D of C.
4. Grassbag Fabric.
To prevent accidents cut off the long ribbon attached to
the grassbag and discard. (Refer fig.1)
Handlebar
Unscrew the handlebar securing knobs sufficiently to
allow the handlebar to pivot.
Unfold the handlebar to the operating position.
Tighten all handlebar knobs to secure in position.
(Refer fig.2)
Take care to ensure that the power cable does not
become snagged at the pivot points.
Grassbag Attachment
Once the grassbag is assembled. Raise the rear deflec-
tor, pass the grassbag under the handlebar and hook into
position. Lower the rear deflector to rest on the grassbag.
(Refer fig.3)
Fig. 1
Fig. 2
Supply Cable
Route the supply cable loosely across to the cable cleat
on the left side of the handlebar. Make a loop in the
supply cable and secure to the cable cleat. (Refer fig.4)
Fig. 3
Fig. 4
7
Advertisement
Table of Contents
