Assembling The Mower Before First Use; Delivery Checklist; Handle; Grassbag Assembly - Hayter Harrier 41 Push Owner's Handbook Manual

ASSEMBLING THE MOWER BEFORE FIRST USE

Delivery Checklist

Remove the mower from the packaging and check that the
following items have been supplied correctly. If any items are
missing, contact your local Hayter dealer.
1. Engine Handbook
2.

Grassbag Assembly

3. Parts List
4. Declaration of Conformity
To prevent accidents cut off the long ribbon attached to the
grassbag and discard.
(Refer fi g.1)

Handle

Take care to ensure that the control cables do not become
snagged at the pivot points.
Unscrew the handle securing knobs suffi ciently to allow the
handle to pivot. Hold the engine stop lever in towards the handle
and unfold the handle to the operating position, then release.
Tighten both handle knobs to secure in position.
(Refer fi g.2)
Fig. 1 Fig. 2
Grassbag Assembly
Before fi rst use assemble the grassbag and frame. Slide the
frame (1) into the grassbag (2), ensuring that the handle is
above the grassbag as shown. Attach plastic clips (A), (B), (C)
and (D) to the grassbag frame.
Raise the rear defl ector, lower the grassbag and hook into posi-
tion. Lower the defl ector to rest on the grassbag.
(Refer fi g.3)

Prevent Engine Damage

To prevent engine damage the engine is shipped without oil
or fuel. The engine must be fi lled with the correct grade of
oil and fuel before starting the engine. Please refer to your
engine manual for more information.

Oil Type

Always use high quality detergent oil classifi ed SAE 30 oil.
Never use additives with recommended oil. To prolong the life
of your engine it is important that the oil is changed after the fi rst
5 hours of use.
(Refer fi g.4)
Fig. 3
2
1
A
B
D
C
9

Check Oil Level

Before adding or checking the oil, ensure the engine is level and
the oil fi ll area is clear of debris.
To add oil:
1. Remove the dipstick (A) and wipe with a clean cloth.
2. Insert and tighten the dipstick (A).
3. Remove the dipstick and check the oil level. Correct oil
level is at the top of the full indicator (B).
4. If oil level is low, slowly add oil into the engine oil fi ll. DO
NOT OVERFILL. After adding oil, wait one minute and
then recheck the oil level.
5. Re-insert and tighten the dipstick (A).
(Refer fi g.5)
Fig. 4 Fig. 5
A
B