Assembling The Mower Before First Use; Delivery Checklist; Handlebar; Grassbag Assembly - Hayter Spirit 41 617J Owner's Handbook Manual

ASSEMBLING THE MOWER BEFORE FIRST USE

Delivery Checklist

Remove the mower from the packaging and check that the
following items have been supplied correctly. If any items are
missing, contact your local Hayter dealer.
1. Engine Handbook
2.

Grassbag Assembly

3. Parts List
4. Declaration of Conformity
To prevent accidents cut off the long ribbon attached to the
grassbag and discard.
(Refer fi g.1)

Handlebar

Unscrew the handlebar securing knobs suffi ciently to allow the
handlebar to pivot. Hold the engine stop lever in towards the
handlebar and unfold the handlebar to the operating position,
then release. Ensure the knobs are assembled to the outside of
the handlebar.
Tighten all handlebar knobs to secure in position.
(Refer fi g.2)
Take care to ensure that the power cable does not become
snagged at the pivot points.
Fig. 1 Fig. 2
Grassbag Assembly
• Insert the metal frame into the grassbag fabric.
• Clip into position.
(Refer fi g.3)

Grassbag Attachment

Once the grassbag (3) is assembled, raise the rear defl ector (1),
pass the grassbag through the handlebar and hook into position
(2). Lower the rear defl ector to rest on the grassbag.
(Refer fi g.4)

Prevent Engine Damage

To prevent engine damage the engine is shipped without oil
or petrol. The engine must be fi lled with the correct grade of
oil and petrol before starting the engine. Please refer to your
engine manual for more information.

Oil Type

Always use high quality detergent oil classifi ed SAE 30 oil.
Never use additives with recommended oil. To prolong the life
of your engine it is important that the oil is changed after the
fi rst 5 hours of use. Please refer to the Maintenance Schedule in
this Handbook.
(Refer fi g.5)
Fig. 3 Fig. 4
2
1
8
RELEASED Ver-A.0

Check Oil Level

Place engine level.
Clean the oil fi ll area of any debris.
• Remove the dipstick and wipe with a clean cloth.
• Insert and tighten the dipstick.
• Remove the dipstick and check the oil level. It should be at
the top of the full indicator on the dipstick.
• If low, add oil slowly into the engine oil fi ll. Do not
overfi ll. After adding oil, wait one minute and then recheck
the oil level.
• Replace and fully tighten dipstick.
(Refer fi g.6)
Fig. 5
3
1
2
g017679
©Toro 2015
Fig. 6
0.15 L