Tractor Controls - Snapper 2690978 LT2146 Operator's Manual

Tractor Controls
W
B
m
Brake Pedal
Depressing the brake pedal applies the tractor
brake,
Cruise Control
This locks the ground speed control in forward.
The cruise control has five lock positions.
Electronic Dashboard
See Electronic Dashboard section.
Fuel Tank
To remove the cap, turn counterclockwise.
Ground Speed Pedals
The forward ground speed pedal controls the
tractor's forward ground speed. The reverse
ground speed pedal controls the tractor's reverse
ground speed.
Headlight Switch
This turns the tractor headlights on and off.
Height-of-Cut Switch
This adjusts the mower cutting height. Press the
switch UP to raise the mowing cutting height
and DOWN to lower the mower cutting height.
The height-of-cut is displayed on the electronic
dashboard.
Parking Brake
This locks the parking brake when the tractor is
stopped. See Parking Brake section.
Power Outlet (12V-DC)
The power outlet is 12V-DC. Accessories must be
rated at 9 amps or less.
Power Take-Off (PTO) Switch
This engages and disengages attachments that
use the PTO. To engage the PTO, pull UP on the
switch. Push DOWN to disengage.
NOTE: The operator must be seated firmly in the
tractor seat for the PTO to function.
Reverse Mowing Option (RMO)
This allows the operator to mow (or use other
PTO driven attachments) while traveling in
reverse. To activate, turn the RMO key after the
PTO is engaged. The L.E.D. light will illuminate,
and the operator can then mow in reverse. Each
time the PTO is engaged, the RMO needs to be
reactivated if desired.
Ignition Switch
The ignition switch starts and stops the engine, it
has three positions: OFF, RUN, and START.
STOP Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN
position with the engine stopped. This will drain
the battery.
Throttle/Choke Control (Choke-A-Matic)
The throttle/choke controls the engine speed
and choke. Move the throttle/choke control to
the FAST position to increase engine speed and
SLOW position to decrease engine speed. Always
operate at full throttle. Move the throttle/choke
control to the CHOKE position for starting a cold
engine. A warm engine may not require choking.
Transmission Release Lever
This releases the transmission so that the tractor
can be pushed by hand.
(_ 13