Advertisement
Assembly
M5 x 1
13
/
" Screw -2
16
Metal Canopy Stay
Upper
Hole
8
Slot
• Position one end of the metal canopy stay against the
upper hole in a frame.
• Insert an M5 x 1
/
" screw through the hole in the cover.
13
16
• Fit the end of the screw through the hole in the metal
canopy stay and into the upper hole in the frame.
• Push on the cover to insert and "snap" the tab on the cover
into the slot in the frame. Make sure you hear a "snap".
• Fit an M5 lock nut (with the rounded side toward the
fabric) into the upper hexagonal opening on the back
of the frame.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other end of the metal
canopy stay and the remaining cover to the frame on the
other side of the base.
Rounded
Side
M5 Lock Nut -2
Cover
Tab
Pad
Fastener
9
• Fasten the pad fasteners to the base fasteners.
• Lift the canopy.
• Attach the toys to the canopy fasteners.
IMPORTANT! Assembly is now complete, but Bounce 'n Play
Activity Dome is not ready for use. Please refer to the Use
instructions, on this page, beginning with step 2.
6
Toys
Canopy
Fasteners
Advertisement
