Advertisement
Note: If a passcode is enabled, the console will
regularly ask for you to enter the passcode. The
console will remain locked until the correct pass-
code is entered. IMPORTANT:
If you forget your
passcode, enter the following
master passcode
to unlock the console: 1985.
12. Enable or disable the safety zone feature.
The treadmill features ultrasonic sensors that can
detect objects that may come too close to the back
of the treadmill, such as children or pets.
To enable or disable the safety zone sensor, first
touch the Safety Zone button. Next, touch the
Enable checkbox or the Disable checkbox. Then,
touch the back button on the screen.
13. Exit the equipment settings mode.
To exit the equipment settings mode, touch the
back button on the screen.
NOW TO USE THE MAINTENANCE
MODE
1.
Select the settings main menu.
See step 1 on page 21.
2.
Select the maintenance
mode.
In the settings main menu, touch the Maintenance
button to enter the maintenance mode.
The mainte-
nance mode
main screen
will show infor-
mation about
the model and
version of the
treadmill.
MAINTENANCE
,t:;_C2 ''°°;,.......... _
3.
Update the console firmware.
For the best results, regularly check for firm-
ware updates.
Touch the Firmware Update button to check for
firmware updates using your wireless network. The
update will begin automatically.
To avoid damaging the treadmill,
do not turn off
the power or remove the key while the firmware
is being updated.
The screen will show the progress of the update.
When the update is complete, the treadmill will turn
off and then turn back on. If it does not, press the
power switch into the off position. Wait for several
seconds, and then press the power switch into the
reset position. Note: It may take a few minutes for
the console to be ready for use.
Note: Occasionally, a firmware update may cause
your console to function slightly differently. These
updates are always designed to improve your exer-
cise experience.
4.
Calibrate the incline system of the treadmill.
Touch the Calibrate Incline button. Then, touch
the Begin button to calibrate the incline system.
The treadmill will automatically
rise to the maxi-
mum incline level, lower to the minimum incline
level, and then return to the starting position. This
will calibrate the incline system. Press the Cancel
button to return to the maintenance mode. When
the incline system is calibrated, touch the Finish
button.
iMPORTANT: Keep pets, feet, and other objects
away from the treadmill
while the incline sys =
tern is calibrating. In an emergency,
pull the key
from the console to stop the incline calibration.
5.
View machine information.
Touch the Machine Info button to view information
about your treadmill. After you view the information,
touch the back button on the screen.
6.
Find keycodes.
The Keycodes button is intended to be used by
service technicians to identify whether a certain
button is working correctly.
7.
Exit the maintenance mode.
To exit the maintenance mode, touch the back but-
ton on the screen.
22
Advertisement
