Advertisement
ASSEMBLY
Assembly
requires
two persons.
Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
in addition
to the included tool(s),
assembly
requires a Phillips screwdriver
_
and a rubber
mallet c__.
As you assemble the elliptical exerciser, use the drawings below to identify small parts, The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual, The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M8 x 16mm x 2mm
Washer (120)-2
M6 Split Washer
(112)-8
1
M8 x 23mm x 2mm
Washer (126)-2
M8 Split Washer
(103)-14
M6 x 12mm Patch
Screw (111)-8
M8 x 23,5mm x lmm
Washer (110)-2
M10 Split
Washer (123)-4
M4 x 16mm
Screw (93)-4
M8 x 16mm Patch
Screw (102)-16
M10 x 80mm Patch
Screw (100)-4
Small Wave
Washer (118)-2
M4 x 16mm
Round Head
Screw (106)-8
M8 x 23mm Shoulder
Patch Screw (121 )-2
Medium Wave
Washer (119)-2
M4 x 19mm
Flat Head
Screw (117)-1
5
Advertisement
