Fisher & Paykel E402B Installation Instructions And User Manual page 24

Trouble shooting
22
Problem
Water has poor
taste/odour.
Water dispenser
does not work
and/or icon
flashing.
Water in first glass
is warm.
Filter warning light
is flashing.
Wet ice/ice
clumping.
Measured Fill
amount of water is
inaccurate.
Possible Causes
Refrigerator not used for an
extended period.
Water supply turned off or not
connected.
Supply line may be blocked.
On first installation there may be
air in water system.
Filter may be blocked and need
replacing.
Dispenser lock activated.
Water frozen in tank.
Water dispenser not used for
extended period.
Tank capacity used recently.
Filter needs replacing.
Low water pressure.
Filter blocked.
Long freezer door openings
High ambient temperature
Ice bin left out of freezer
compartment a length of time
Ice will stick together over time.
Measured Fill needs
recalibration.
What to Do
Dispense 3 L or 3 qt water so fresh water
supply is replenished.
Turn water on.
Press dispenser for 2 mins to remove
trapped air from water line and to fill
the water system.
Check supply for kinks or leaks.
To remove air, run a litre or a quart of
water through the dispenser.
Replace filter (see back of this booklet
for Customer Care contact details).
Hold down the and
seconds.
Increase temperature to a warmer
setting in fresh food compartment and
freezer.
Allow 24 hrs for water to cool to set
temperature.
Allow water time to cool.
Replace filter as soon as possible (see
pages 18 – 19).
Check water pressure.
Replace filter (see pages 18 – 19).
Gently tap ice with scoop to unstick or,
if large clumps occur, empty ice bin and
make new ice.
Recalibrate (see page 20).
button for 2