Table of Contents
Advertisement
_
AUTION:Priorto operatingyour
(f
snowthrower,referto Auger Control
Teston page 11. Readand follow all
instructions carefully, and performall
adjustments to verify yoursnowthrower
is operatingsafelyand properly.
Shear Pin Storage
An areafor convenientshearpin storageis located under
the plasticdashpanel,See Figure7,
Chute
Clean-Out
Tool
The clean-outtool is conveniently fastenedto the rearof
the auger housingwith a mountingclip, See Figure8,
1, Releaseboththe augercontroland the drive/auger
control lock.
2, Stop theengine bymovingthe throttleto the stop
position,
3, Removethe clean-outtool from the mountingclip,
4, Usethe shovel-shaped end of the clean-outtoolto
removeany snowand ice in the chute assembly,
5, Re-fasten the clean-outtoolto the mountingclip on
the rearof the augerhousingand restartengine,
6, Whilestandingin the operator'sposition(behindthe
snow thrower),engagethe auger controlfora few
secondsto clearany remainingsnowor ice fromthe
chute assemblybeforecontinuingto clearsnow,
__i=
ARNING:Never use yourhands to
clean snow and ice from the chute
assembly or auger housing.
Figure 6
Tire Pressure
The tires are over-inflated for shippingpurposes,Check
the tire pressurebeforeoperatingthe snowthrower,Refer
to the tire sidewall for tire manufacturer's recommended
psi and deflate(or inflate) t hetires as necessary,
NOTE: Ifthe tire pressureisnot equal inbothtires, the
unit may nottravel ina straightpathand the shaveplate
may wearunevenly.
Figure 7
Chute Clean-0ut T001
B
\
Figure 8
Figure 5
7
CAUTION
Prior to operating
your snow thrower,
refer to Auger Control
Test on page 13.
Read and follow all
instructions care-
fully and perform all
adjustments to verify
your unit is operating
safely and properly,
Advertisement
Table of Contents
