Symbols Meaning - Craftsman WEEDWACKER INCREDI.PULL 316.711370 Operator's Manual

,,
SAFETY & iNTERNATiONAL SYMBOLS ,,
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's
manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
'_,SAFETY ALERT SYMBOL A
,_ Indicates danger, warning or Caution. May be used in
I conjunction with other symbols or pictographs.
Ill I II| WARNING:
Read the operator!smanUa!(s )
and
follow aHwarnings and safety instruct!onsi Eailure to
do so can result in serious injury to the operator
. and!er bystandersl
4t _ ,,WEAR EYE AND HEARING PROTECTION
WARNING:Thrown Objects and loud noise Can
_---iqll _llll cauSe Severe eye injury and hearing leSS: wear eye
protection meeting ANS! Z87;1 ;1989 Standards and
ear protection when operating this unit Use a full face
I
shle d when needed.
AlwayS Use clean, fresh Unleaded fuel.
*OIL ; Refer to 0perator s manual for the proper tYpe Of oil.
@ *DO NOTUSE E85 FUEL iN THIS UNiT
WARNING:it haS been proven that fUe! €0ntaining
greater than 10% ethanol will likely damage this
engine and void the warranty.
SYMBOL MEANING
|
O _ ON/OFF STOP CONTROL OFF or STOP
, PRIMER BULB
_rJ Push primer bulb fully and slowly 10 times.
rJi
J CHOKE CONTROL
H I'_l I{°l 1.. FULLchoke position
2. • PARTIAL choke position
3. • RUN choke position
__17_ _THROWN OBJECTS AND ROTATING CUTTER CAN
/ _ CAUSE SEVERE iNJURY
/_W// WARNING:
Small objects can be propelled at high
S-_._ speed, causing injury. Keep away from the rotating rotor.
t KEEP BYSTANDERS AWAY
WARNING:
Keep all bystanders especially children
and pets, at least 50 feet (15 m) from the operating area
HOT SURFACE
_ ARNING:
Do not touch a hot muffler or cylinder.
You may get burned. These parts get extremely hot
. from operation. When turned off they remain hot for a
, short time.
._' SHARP BLADE
WARNING:
Sharp blade on trimmer attachment
shield. To prevent serious injury, do not touch the line
cutting blade.