Display Feature - Sears LXI series 580.55914490 Owner's Manual

DISPLAY FEATURE
Pressing the DISPLAY button lets you check several special displays in the viewfinder.
Tape counter:
When the TAPE COUNTER is on and visible in the viewfinder, a tape that is rewound will automatically stop
when the COUNTER reads (approximately) "0000",
This is useful if there is a section of tape you want to review immediately after recording or if you want to return
to the same point several times in a row,
1. Press the DISPLAY button until the tape counter
is displayed.
2. Slide "CAM/OFFNCR" select switch to VCR.
3. Start playing.
At the point you want playback to start, press the
RESET button to reset the counter.
.
6.
Press the STOP button when finished playing.
Press the REW button. The tape will be rewound
to the preselected point ("0000").
NOTE:The tape will also stop at "0000" during
Fast Forwarding.
4. Continue to play.
Time remaining feature:
When the tape counter is displayed in the viewfinder.
1. Press the DISPLAY button to change the display
or to show the amount of recording or playback
time left on the tape.
2. Press the DISPLAY button again to remove the
tape counter from the viewfinder.
NOTE: When using an extended length T-160
cassette, you must press the RESET button to
adapt the camcorder time remaining feature for
accurate reading.
("T-160"character display).
1st press 2nd press 3rd press
DISPLAY button DISPLAY button DISPLAY button
Eoooo I ;Io oo oo I +I
TR1:30
l°RI 1 +
T160
TR1:30
Battery remain indicator:
Press the DISPLAY button until battery remain indicator is displayed.
I E FI E I
BATTERY LEVEL
(shown fully charged)
BA'i-rERY LEVEL
(Partially discharged)
E_ F1 i +E F 1
BATTERY LEVEL (low) AFTER SEVERAL
REPLACE WITH A CHARGED SECONDS,
BATTERY THE POWER WILL
GO OFF
28