Central Machinery 93380 Assembly And Operating Instructions Manual page 18

STANDARD
TABLE INSERT
(116A)
SET SCREW
(117A)
To Install The Blade Guard Assembly:
1. Thread the blade guard Shaft (74) into the hole in the Back Trunnion (75) located
at the rear of the Table Saw, and firmly tighten the Shaft. (See Figure M.)
2. Place the Lower Guard Bracket (120) over the Shaft (74), and tighten the two
Set Screws (121). (See Figure M.)
3. Place the L-Bracket (122) onto the Lower Guard Bracket (120). Secure the L-Bracket
to the Lower Guard Bracket, using two Bolts (129), two Elastic Washers (128), and
two Flat Washers (127). Do not tighten firmly at this time. (See Figure M.)
SKU 93380 For technical questions, please call 1-800-444-3353.
SET SCREW
(117A)
SET
SCREW
(121)
SET SCREW
(117B)
SPLITTER (315)
BOLT (123)
FLAT WASHER (124)
ELASTIC WASHER (125)
NUT (126)
L-BRACKET (122)
BOLT (129)
ELASTIC WASHER (128)
FLAT WASHER (127)
SHAFT (74)
LOWER
GUARD BRACKET
(120)
SET SCREW
(117B)
FIGURE L
FIGURE M
Page 18