Chicago Electric 91852 Assembly And Operating Instructions Manual page 7

16. Turn off the Saw and allow the Saw Blade to stop on its own if the Saw
Blade is to be backed out of an uncompleted cut.
Industrial applications must follow OSHA requirements.
17.
18. The Laser on the Miter Saw is rated as a Class 2. Do not stare directly at the
Laser beam. A hazard may exist if you deliberately stare into the beam. Never
aim the Laser beam at any person, animal, or an object other than the work-
piece.
Make sure the Laser beam is aimed at a sturdy workpiece without reflective
19.
surfaces. Reflective surfaces are not suitable for Laser applications, as the re-
flective surface may direct the Laser beam back at the operator, causing potential
eye damage.
Do not attempt to alter the Laser or replace it with a different type. Doing so
20.
may result in hazardous radiation exposure.
Never attempt to remove material stuck in the moving parts of the Miter
21.
Saw while the machine is plugged in and running.
22. Whenever possible, use clamps or other safe, practical ways to hold and
support the workpiece. Do not attempt to cut material that does not have a flat
surface, unless a suitable support is used.
Always keep hands and fingers away from the spinning Saw Blade.
23.
Use eye, hearing, and breathing protection. Always wear ANSI-approved
24.
safety impact eye goggles, hearing protectors, and dust masks or respirator
when working with the Miter Saw.
Do not use this product if under the influence of alcohol or drugs. Read
25.
warning labels on prescriptions to determine if your judgement or reflexes are im-
paired while taking drugs. If there is any doubt, do not attempt to use this prod-
uct.
26. Maintain this product with care. Keep the Miter Saw clean and dry for better
and safer performance. For your safety, service and maintenance should be per-
formed regularly by a qualified technician.
27. Use the right tool or attachment for the right job. Do not attempt to force a
small tool or attachment to do the work of a larger industrial tool or attachment.
There are certain applications for which this product was designed. It will do the
job better and more safely at the rate for which it was intended. Do not modify
this product, and do not use this product for a purpose for which it was not in-
tended.
Always turn off the Miter Saw and unplug the Power Cord (27) from its
28.
electrical outlet before changing accessories or performing inspection,
maintenance, or cleaning procedures.
For technical questions, please call 1-800-444-3353.
SKU 91852 PAGE 7