Chicago Electric 91852 Assembly And Operating Instructions Manual page 19

make sure the Saw Blade (4) does not contact the bottom of the Work
Table (87) or any other part of the Saw Base. (See Figure P)
LONG BOLT (133B)
SHORT
BOLT (133A)
FIGURE P
7. If the Saw Blade (4) touches the Work Table (87) or any other part of the Saw
Base, turn the two Bolts (133A,133B) clockwise to raise the Saw Blade slightly
until it clears. (See Figure P.)
To Adjust The Miter Angle:
WARNING! Prior to performing this procedure, make sure the Power
1.
Cord of the Miter Saw is unplugged from its electrical outlet.
2. The miter angle of a cut may be adjusted 0 - 45 degrees to the right or left. To
do so, loosen the Fasten Knob (153) located at the front of the Work Table (87).
(See Figure Q.)
3. Move the Work Table (87) to the right or left until the desired miter angle of cut is
indicated by the Miter Scale located on the Base (100). Then, retighten the Fas-
ten Knob (153) to lock the Miter Saw in place. (See Figure Q.)
WORK TABLE
(87)
FIGURE Q
For technical questions, please call 1-800-444-3353.
SKU 91852
SAW BLADE (4)
BASE (100)
KERF BOARD
WORK TABLE (87)
FASTEN KNOB
(153)
(151)
REV 12/05
PAGE 19