GE JS905 Owner's Manual page 13

Usingthe clock, timer and controllockout, geoom
Makesure the clockis setto the
correct timeof day.
To Set the Clock
The clock must be set to tile correct time
of day for tile automatic oven timing
tractions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
[77 Press the CLOCK pad.
[] Press tile number pads.
[_] Press the START pad.
_,_ TIMER _ITCHEN
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Set the timer
_] Press tile KITCHEN TIMER ON/OFF
pad.
Press die number pads until die
amount of time you want shows in
die display. For example, to set 2
hours and 45 minutes, press 2, 4[
and 5 in that ordeL
If you make a mistake press die
KITCHEN TIMER O N/OFF p ad
and
begin again.
[_ Press the STARTpad.
After pressing theSTART pad,SETdisappears,
this tellsyouthetimeis counting down,although
thedisplay doesnotchange untiloneminutehas
passed. S econds will notbe shownin thedisplay
untilthelast minuteiscounting down.
[_ x4qien the timer reaches :00, die
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad
is pressed.
The6-secondtone can be canceled by following
the steps in the Specialfeatures of your oven
control section under Tonesat the Endof a
timed Cycle.
To Reset the timer
If die display is sdll showing die dine
remaining, you may change it by pressing
the KITCHEN TIMERON/OFF pad, then
press die number pads until die dine you
want appears in die display.
If die remaining time is not in die display
(clock, delay start or cooking time are in
die display), recall die remaining dine by
pressing die KITCHEN
TIMER O N/OFF
p ad
and then pressing die number pads m
enmr die new dine you want.
To Cancel the timer
Press the KITCHEN TIMERON/OFFpad
twice.
LOCK/UNLOCK HOLD 3 SECONDS
Control Lockout
Your c ontrolwit allowyoutolockoutthepress
padsso theycannot b e activated whenpressed.
To lock/unlock die conuols:
[77 Press die 9 and 0pads at die same
dine for 3 seconds, until die display
shows LOCON.
To unlock die control, press die
9 and 0 pads at die same time for
3 seconds, until die display shows
LOC OFF
X_qien this feature is on and die press
pads are pressed, die control will beep
and die display will show LOC ON.
Thecontrollockoutmodeaffectsall press
pads.Nopress padswill work whenthis
feature is activated.
Theadjustment w ill be retainedin memory
after a powerfailure.
73