Using The Surface Units - GE JS905 Owner's Manual

Using thesurfaceunits.
Throughout this manual, features and appearance may vary from your model
LO HI
Be sure you turn the control
knob to OFFwhen you finish
cooking.
How to Set
Push die l_ob in and mrn in eidler
direction to tile setting you want.
At bodl OFF and/4/tile control clicks into
position° You nlay hear slight clicking sounds
during cooldng, indicating the control is
keeping the power level you set.
A HOTSURFACE indicator light, on the
cooktop, will glow when any radiant eleInent
is turned on. It will renlain on until the
surfitce is cooled to approximately 150°F
(66°C).
stayon evenafter theunitis turnedoff.
glow untiltheunitis codedto approximately
150°F(66°C).
4 ¸¸ 5 ¸
Hot surfaceindicator light will:
come on whentheunitis hotto thetouch.
Tile WARM setting on tile right REAR surtZace
unit keeps aheady heated food waml until
ready to serve. Do not use to heat cold food.
Dual Surface Unit Control Knob
Theright front surface unit has 2 cooking sizesto
select from so you can match the sizeof the unit to
the size of the cookwareyou are using.
To use tile snlall
(G-inch)
surface unit, t/lIII
tile control knob to tile
SMALl.
settings.
To use die large (9-inch) surface unit, mrn
tile control knob to tile LARGE settings.
SMALL _ LARGE
\
tO
WARMING ZONE GUIDE
SETTING FOOD
1 (Low) Bread/Pastries
2 (Medium) Chocolate/Butter
2 (Medium) Sauces, S tews,
Cream Soups
2 (Medium) Vegetables
3 (High) Soups (liquid)
3 (High) Teaor Coffee
The Warming Zone Guideisfor
reference only andthe SETTING
that you needwill depend on the
amount andtype of food, the
startingtemperature of the food
andthe length of the holdingtime.
6
Using the Warming Zone
Tile WARMING ZONE, located
in tile
center of tile glass cooktop surface,
will keep hot, cooked food at serving
temperature. Ahvays start widl hot food.
Do not use m heat cold food. Placing
uncooked or cold food on tile WARMING
ZONE could result in food-borne illness.
%
%
Touch tile WARMINGZONEpad.
Touch tile number pads 1, 2 or 3
to select low (1), medium (2) or
high (3) warming setting.
Touch tile STARTpad.
To mrn die WARMINGZONEoff, much
die WARMING ZONE pad until WARMER
di_ppeaxs from the display.
For best
results,
all foods on tile
WARMINGZONEshould be covered widl
a lid or ahmlinum foil. When warming
pasuies or breads, tile cover should be
venmd m allow moisture m escape.
Always use pot holders or oven mitts
when removing food flom tile WARMING
ZONE, since cookware and plates will
be hot.
CAUTION; Do notwarm food on the
WARMING ZONE for more than two hours.
NOTE: Thewarming zone will not glow rod like
the cooking elements.
HOTwill be displayed when tile glass
surface is hot and will remain on until
tile surface is cool enougll to touch.
NOTE: Lower settings may not heat the glass
surface enough to cause the HOTindicator light
to come on,
A warming zone ONlight will glow when
tile unit is on.
Donot useplasticwraptocoverfood.Plastic
maymelt ontothesurfaceandbe verydifficult
to clean.
Useonlycookware recommended for
top-of-range c ooking.