Before Replacing - GE Appliances JGBS04 Owner's Manual And Installation Instructions

GEAppliances.com
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the
surface.
This will help you to maintain the brightness
and appearance of your stainless steel range.
In order to avoid any discolorations and/or
grease stains, we recommend cleaning and
removing any spills,spots and grease from
the range after use.
It is important to use a soft cloth or paper
towel every time the range is cleaned to
avoid any scratches.
Readcarefully the instructions on the back of
the Brightener for better results.
Cleaning Instructions:
1. Removegrates.
2. Wash using warm, soupy water:
Wet soft cloth or paper towel (avoid using
excessive water).
Wipe the surface in the direction of the grain
(following the steel lines).
Rinseand wring out u soft cloth or paper
towel and dry the range.
3. Apply a degreaser that does not contain
sodium hydroxide or stainless steel cleaner
(follow instructions).
& Repeat steps 2-4 as many times as needed.
5. Put grates back in place.
Follow these instructions for any stainless steel
surface on your range.
DO NOT USEfor cooktop or stainless steel
parts cleaning:
. Caustic lye (sodium hydroxide) or cleaners
containing this chemical
. Hard or steel wool pads
. Abrasive materials or chemicals
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
toll-free number:
National Parts Center 800.626.2002 (U.S.)
800.561.1515 (Canada)
GEApplianceParts.com (U.S.)
www.GEAppliances.ca (Canada)
iA i
WARNING
l n I Shock or Burn Hazard: Before replacing oven light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
Oven Light Replacement (on some models)
Replace bulb with a 40-watt appliance
Be sure to let the light cover and bulb cool [] bulb or two-prong halogen bulb, as
completely.
To remove the coven appropriate.
r_ Twist lens counterclockwise about a
quarter turn to remove.
Do not remove any screws to remove the cover.
To replace the coven
[-_ Line up tabs of lens in front of tabs on
housing and rotate clockwise to engage.
i i i _ii iiiii i
Wide cover holder.
Oven Light Replacement (on some models)
ACAUTION Before
replacing
your oven light bulb, disconnect the electrical
power to the range at the main fuse or circuit
breaker panel. Be sure to let the light cover
and bulb cool completely.
The oven light bulb is covered with a remov-
able glass cover that is held in place with a
bail-shaped wire. Remove the oven door, if
desired, to reach cover easily.
To remove:
% Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
[Z] Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center of the cover.
[_ Connect electrical power to the range.
33