Operation; Section 9: Start-Up Sequence; Honeywell Intermittent Pilot; For Your Safety - Read Before Lighting - Montigo R320-ST Installation & Maintenance Manual

R320-ST & 420 ST Power Vent Indoor Gas Fireplace
1) Turn the wall switch ON
2) The blowers will start and within 10 seconds the glow plugs will
start to glow
3) If the pilot does not light the gas valves willl turn the glow plugs
off after 20 seconds
4) This may need to be done three or four times to bleed all of the
air out of the gas lines within the fireplace

Honeywell Intermittent Pilot

A. This appliance is equipped with an ignition system that lights
the pilot burner automatically. Do not attempt to light the pilot
by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Page 24

Operation

XW2008
STARTUP SeqUenCe:
XW2040
Operation

FOR YOUR SAFeTY - ReAD BeFORe LIGHTInG:

WARNING
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
5) Turning the switch OFF and then ON again will reset this start
up sequence
6) Once the pilots are burning the main burner will turn on and
the fireplace will be functional for a quick start up on next use.
CAUTION
■ This fireplace has been set up at the factory for a
determined air volume though the venting system.
■ This fireplace will not operate unless the correct
air movement is detected by our control system..
■ Please consulted with your contact person at
Montigo should you have any problems with your
start up.
■ Do not try to light any appliance.
■ Do not touch any electrical switch; do not use any phone in your
building.
■ Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
■ If you cannot reach your gas supplier, call the Fire Department.
C. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.

Section 9: Start-up Sequence

XG0772 - 030711