System Installation; Base Unit; Gateway - Aastra 6753i R Administrator's Manual

System Installation

Base Unit

Gateway

AastraLink RP System Administrator Guide
The AastraLink RP Solution uses auto-discovery to sense the system components.
Before installing the Response Point software on the system administrator's PC, all
other components of the AastraLink RP Solution must be installed, plugged in, turned
on (if applicable), and connected to the LAN.
Note: All phones, base units and gateways must be connected to the same LAN in
order for the AastraLink RP Solution to function as designed.
The AastraLink 500 Base Unit should be installed following the instructions given in
the AastraLink 500 Base Unit Installation Guide or AastraLink RP Solution Quick
Start Guide.
The AastraLink 500 Base Unit may be installed as a desktop unit flat on the desk or
on end, or may be wall-mounted to save space.
The AastraLink 500 Base Unit must be connected to both power and the LAN, and
must be turned on for auto-discovery to succeed.
The AastraLink RP 540 Gateway should be installed following the instructions given
in the AastraLink 540 Base Unit Installation Guide or AastraLink RP Solution Quick
Start Guide.
The AastraLink RP 540 Gateway may be installed on a desktop, stacked under an
AastraLink RP 500 Base Unit, or wall-mounted.
11