Table of Contents
Advertisement
3.
attach the rear panel to the stand with the
remaining hex bolts, nuts, and (12) 8mm flat
washers.
Note: If you plan to mount your machine
stand to the floor, do so now (see Mounting
to Shop Floor on Page 14), then return
to Step 4, below, to mount the machine to
the stand. Otherwise, continue with Step 4,
below.
4.
place the saw onto the stand and secure it
with the four m8-1.25 X 35 hex bolts and flat
washers (figure 12).
hex bolt
figure 12. mounting saw onto stand.
5.
attach the handle by threading it into the
gearbox head, then tightening the jam nut, as
shown in figure 13.
handle
figure 13. installing handle.
-16-
saw base
stand
Jam Nut
gearbox head
6.
Connect the handle switch plug to the control
box by aligning the plug with the socket, then
threading the lock collar (figure 14).
socket
figure 14. Connecting switch plug.
7.
Connect the support roller to the machine
base by removing the two hex bolts, align-
ing the bracket over the holes, as shown in
figure 15, then re-installing the hex bolts.
before fully tightening the hex bolts, use a
straightedge to make sure the roller is even
with the vise table.
machine base
hex bolts
figure 15. support roller.
g0682 12" Cold Cut saw (mfg. since 12/10)
switch plug
lock Collar
support roller
Advertisement
Table of Contents
