Marantz DVD Player User Manual page 55

Remote control operation is not possible.
The rear panel control input jack on the player is being
used.
\ Point the remote control at the component that the
player is connected to (page 14).
The remote control is too far from the player, or the angle
with the remote sensor is too wide.
\ Be sure to operate the remote from a location within its
operating range (page 6).
The batteries are exhausted.
\ Replace the exhausted batteries with all new batteries
(page 6).
Audio is not output or is distorted.
The Setup screen Audio 1 menu [96 kHz PCM Out]
setting is set to [96 kHz]. Digital output is prohibited on
some discs.
\ On DVDs that contain copy protection, it may not be
possible to play back the audio at 96 kHz.
\ When this type of disc is encountered, even if [96 kHz]
is selected, the player automatically outputs the audio
at a compressed rate of 48 kHz. This is not a
malfunction.
\ The [4:3 (Letter Box)] screen setting is selected. Even if
[96 kHz] is selected, the player automatically downsamples
the audio to a compressed rate of 48 kHz. This is not a
malfunction.
\ Be sure to make analog audio connections as well as
digital connections (page 11, 12).
The disc is dirty.
\ Refer to 'Disc Care' (page 51).
The connection plugs are not inserted fully into the
terminals or are not connected.
\ Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\ Check that the plugs and terminals are wiped clean of
dirt, etc.
Audio cable connection is wrong.
\ Check to make sure that the audio cables are
connected correctly (page 10-12).
Connection is made to the stereo amplifier's PHONO input
terminal.
\ Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\ Press PLAY 3 to exit the pause mode.
Stereo amplifier operation is incorrect.
\ Check input (CD, AUX, etc.) selector to determine if it
is selected for DVD playback.
Noticeable difference in DVD and CD volume.
DVDs and CDs use different recording methods.
\ This is not a malfunction.
Audio mix does not sound right or sounds incomplete
(for example, the dialog of the actors cannot be heard).
Audio output selection is incorrect.
\ When [5.1 Channel] audio output is selected, the front
right (R) and left (L) audio channels are also output
from the SYSTEM AUDIO OUT jacks. Similarly, when
[2 Channel] audio output is selected, the stereo
channels are also output from the front right (R) and left
(L) audio channels of the 5.1 CH SURROUND AUDIO
OUT jacks. Check that the correct output is selected
(pages 17, 27, 28).
Caution
Static electricity or other external influence may cause
malfunctioning of this unit. In this case, unplugging the
power cord and then re-plugging it in will usually reset the
unit for proper operation. If this does not correct the
problem, please consult your nearest MARANTZ service
center.
ENGLISH
55