Lexicon MPX NATIVE REVERB PLUG-IN Owner's Manual page 12

Processing multiple tracks: If using the MPX Native Reverb Plug-In to process
multiple tracks, you need to have an available aux channel (sometimes referred to
as a group channel, group track, or aux track). You must then assign a bus as the
input to this new aux channel then route the aux sends – for all tracks in which you
would like to apply the reverb effect – to this new aux channel. The below diagram
shows an
example
of such a
configuration
within Logic .
®
Please refer
to your DAWs
documentation
if you are
unsure how
to add an aux
channel, assign
busses, and
configure aux
sends within
your DAW.
8
9
MPX Native Reverb
Source Track Reverb Aux Channel
Aux Send
Insert MPX Plug-In
Bus
Assignment
Wet Signal
Dry Signal
DAW Stereo Output
Legend
Callout
Audio Signal