Table of Contents
Advertisement
Brushcutter Handlebar
A brushcutter handlebar or barrier bar helps prevent the operator from moving forward, or the unit moving rearward, thus
preventing inadvertent bodily contact with the blade. ALWAYS KEEP THE HANDLEBAR OR BARRIER BAR SECURELY
IN PLACE ON THE UNIT!
Brushcutter harness
A harness provides additional protection against blade thrust. In addition, a harness gives significant support and comfort
to help ensure safe and efficient operation. When operating a unit with a blade, make sure both the handle and harness
are adjusted to the size of the operator using the unit.
Engine Operating Speeds
Operate the unit at full throttle while cutting. Best fuel efficiency is obtained by releasing the throttle when swinging back
after a cut.
■
To prevent possible engine damage, do not allow the brushcutter to run at high speeds without a load.
■
Avoid operating the engine at low speeds. Doing so can lead to rapid clutch wear. In addition, slow-speed operation tends to
cause grass and debris to wrap around the cutting head.
Using a Blade
The blade rotates counter-clockwise. For best performance and to minimize
being stuck by debris, move the blade from right to left while advancing on
your work. Position the blade so cuts are made between the blade's 8 o'clock
and 10 o'clock positions (as viewed from above). DO NOT cut between the 10
o'clock and 5 o'clock positions.
WARNING!
When cutting wood with a blade, feed the blade slowly—never
strike or "slam" a spinning blade against the wood.
WARNING!
DO NOT use 2-tooth or non-Shindaiwa approved 4-tooth cutting
blades with Shindaiwa trimmers and brushcutters.
Maintenance
General maintenance
MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED
BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A
DEALER OR SERVICE CENTER AUTHORIZED BY ECHO,INC. THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PER-
FORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CON-
TROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.
Using non-standard replacement parts could invalidate your Shindaiwa warranty.
WARNING!
Before performing any maintenance, repair, or cleaning work on the unit, make sure the engine and cutting
attachment are completely stopped. Disconnect the spark plug wire before performing service or maintenance.
WARNING!
Non-standard accessories, cutting attachment, or replacement parts may not operate properly with your unit and may
cause damage and lead to personal injury.
IMPORTANT!
NOTE:
Ten
O'clock
OK To Cut
Eight
O'clock
Blade
Rotation
Five
O'clock
17
Advertisement
Table of Contents
