Long Term Storage - Shindaiwa C242 Owner's/Operator's Manual

Loading Trimmer Line
1. Cut one piece of line to recommended length.
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of trimmer line into an eyelet, and push
line equal distance through trimmer head.
4. Hold trimmer head while turning knob clockwise to
wind line onto spool until about 5" (13 cm) of each line
remains exposed.
Trimmer head is now fully loaded and ready for
operation.
NOTE:
Trimmer head is pre-wound with .095" (2.4mm)
Silentwist™ trimmer line.
When the wear indicators located at the bottom of the Speed-Feed head are worn smooth, replacement of the cover or the
entire Speed-Feed head is required.
Wear Indicators

Long Term Storage

Whenever the unit will not be used for 30
days or longer, use the following proce-
dures to prepare it for storage:
■
Clean external parts thoroughly and
apply a light coating of oil to all metal
surfaces.
■
Drain all the fuel from the carburetor
Indicadores de desgaste
and the fuel tank.
To do so:
1. Prime the primer bulb until no more
fuel is passing through.
2. Start and run the engine until it
stops running.
3. Repeat steps 1 and 2 until the engine
will no longer start.
IMPORTANT!
CAUTION!
Gasoline stored in the carbure-
tor for extended periods can cause
hard starting, and could also lead to
increased service and maintenance
costs.
IMPORTANT!
All stored fuels should be stabilized with
a fuel stabilizer such as STA-BIL™.
NOTE:
Damage resulting from stale or con-
taminated fuel is not covered by the
Shindaiwa warranty policy.
1
.080 (2.0 mm) dia. - 10' (3 m)
.095 (2.4 mm) dia. - 10' (3 m)
3
■
Remove the spark plug and pour
about 1/4 oz. of engine oil into the
cylinder through the spark plug hole.
Slowly pull the recoil starter 2 or 3
times so oil will evenly coat the inte-
rior of the engine. Reinstall the spark
plug.
■
Before storing the unit, repair or
replace any worn or damaged parts.
■
Remove the air cleaner element from
the carburetor and clean it thor-
oughly with soap and water. Let dry
and reassemble the element.
■
Store the unit in a clean, dust-free
area.
2
4
Wear Indicators
Indicadores de desgaste
21