Mounting - La Crosse Technology WS-9065TWC Instruction Manual

MOUNTING

Note: Before permanently mounting ensure that the indoor weather station is able
to receive WWVB signals from the desired location. Also, extreme and sudden
changes in temperature will decrease the accuracy of the indoor weather station, and
changes in elevation will result with inaccurate weather forecasting for the next 12
to 24 hours. These changes will require a 12 to 24 hour wait before obtaining
reliable data. To achieve a true temperature reading, avoid mounting where direct
sunlight can reach the remote temperature sensor or indoor weather station. While
the remote temperature sensor is weather proof, avoid submersion in water or snow.
We recommend that you mount the remote temperature sensor on an outside North-
facing wall. The sending range is 80ft—obstacles such as walls, concrete, and large
metal objects can reduce the range. Place both units in their desired location, and
wait approximately 15 minutes before permanently mounting to ensure that there is
proper reception. The indoor weather station should display a temperature in the
OUTDOOR LCD within 4 minutes of setting up.
4. In sequential order, install batteries (follow the same battery
installation procedures seen in section I. A) of the Detailed Set-Up
Guide).
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and operating
instructions.
B. VIEWING AND OPERATING WITH MULTIPLE REMOTE
TEMPERATURE SENSOR UNITS
1. To view the temperature of a different remote temperature sensor
unit, press and release the CH button. A shift from one "boxed"
number to the next should be observed in the OUTDOOR LCD.
2. To view the Minimum/Maximum temperature: first select which
remote temperature sensor to read data from (indicated by the
"boxed" number), then press the OUT button. Pressing this button
once will display the minimum temperature, and the date and time
the data was recorded. Pressing this button a second time (while
"MIN" is still displayed, otherwise press the button twice) will
display the same data for the maximum recordings.
3. To reset the Minimum/Maximum readings, it is necessary to select
which remote temperature sensor you wish to reset. Press and hold
the OUT button for 5 seconds, the records for the selected remote
temperature sensor unit will be reset.
15