Scag Power Equipment STC Operator's Manual page 32

A. 3" Position - baffle is installed using the top set of
holes on the front baffle welded inside the cutter
deck. (See Figure 6.9). In this position the Velocity-
Plus cutter deck will deliver the best quality-of-cut in
very tall, wiry, tough to cut grass.
B. 3-1/2" Position - baffle is installed using the middle
set of holes on the front baffle welded inside the
cutter deck. (See Figure 6.10). Can be used for
general purpose cutting. Placing the Custom-Cut
Baffle in the 3-1/2" position gives a good mix of
cutting performance in all types of grass.
C. 4" Position (factory setting) - baffle is installed using
the bottom set of holes on the front baffle welded
inside the cutter deck. (See Figure 6.11). Placing the
baffle in the 4" setting will enhance fall cutting (leaf
pickup) and reduce cutter deck "blowout".
To adjust the Custom-Cut Baffle height:
1. Place the cutter deck in the transport position.
2. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck. (See Figure 6.8).
-NOTE-
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on cutter deck size.
MOUNTING
HARDWARE
Figure 6-8. Custom-Cut Baffle
3. Move the Custom-Cut Baffle to desired position.
(See Figures 6.9 through 6.11 for position).
4. Reinstall the mounting hardware as shown. (See
Figures 6.9 though 6.11). Torque hardware to 39 ft/
lbs.
TOP SET OF HOLES
FOR 3" SETTING
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
Figure 6-10. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
FOR 4" SETTING
MOUNTING
HARDWARE
2004 CCB
28
FLATWASHER
Figure 6-9. 3" Custom-Cut Baffle Position
FLATWASHER
FLATWASHER
Figure 6-11. 4" Custom-Cut Baffle Position
Section 6
CARRIAGE BOLT
2004 CCB - 3" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 3-1/2" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 4" Setting
ELASTIC STOP
NUT