Tires; Body, Deck, And Upholstery - Scag Power Equipment STC48V-19KAI Operator's Manual

R
HEX NUT-TORQUE
TO 75 LB-FT
SPINDLE
SHAFT
SPINDLE
ASSEMBLY
WASHER
Figure 7-7. Blade Replacement
- Note -
Be sure that the blade is installed with the lift wing
toward the top.
5. Install the spacer onto the blade bolt and insert the
bolt into the cutter spindle shaft.
6. Install the hex nut to the blade bolt at the top of the
cutter spindle. Secure the blades from rotating and
torque to 75 ft/lbs. See Figure 7-7.
7.10

TIRES

Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels
Drive Wheels
CUTTER
DECK
HEX HEAD
BOLT / NUT
CUTTER BLADE
SPACER
CUTTER
BLADE
HEX HEAD BOLT
Flat Free
12 PSI
7.11

BODY, DECK, AND UPHOLSTERY

CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
1. After each use, wash the mower and cutter deck.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
2. Do not spray electrical components.
3. Use a mild soap solution or a vinyl/rubber cleaner to
clean the seat.
4. Repair damaged metal surfaces using Scag
touch-up paint available from your authorized Scag
dealer. Wax the mower for maximum paint protection.
36
Section 7