Runco LS-3 Series Installation & Operation Manual page 97

Table 6-2. Serial Commands (continued)
Operation Commands
status ?
errcode ?
msgbox = ?
cal.text1 =
cal.text2
cal.text3
Runco LS-3/LS-5 Installation/Operation Manual
Values
0 = Standby
1 = Powering Up
2 = Displaying
3 = Cooling Down
4 = Error
Refer to RS-232 Error
Codes, below.
0 = On
1 = Off
Up to 30 characters.
81
Notes
This control enables or
disables the display of
power off, source and
adjustment message
boxes (brightness, con-
trast etc.). Default value is
ON.
The LS-3/LS-5 start-up
screen is customizable
with three lines of text of
up to 30 characters each.
This text appears below
the "CALIBRATED FOR:"
text in the logo screen.
The allowable characters
are all numbers, letters
(uppercase and lower-
case), spaces, and sym-
bols available in the ASCII
code set.
Serial Communications