Runco LS-3 Series Installation & Operation Manual page 100

Specifications
Table 7-1. LS-3/LS-5 Specifications (continued)
Microdisplay:
Native Resolution:
Aspect Ratios:
Projection Lens:
Throw Ratios:
Vertical Lens Shift Range
(Ceiling Mount):
Horizontal Lens Shift Range:
Video Lumens:
Sequential Contrast –
ConstantContrast On:
Cooling Performance:
Projection Modes:
Lamp:
Video Processing:
Calibration:
Performance
Texas Instruments DLP® 1080p DMD
Full HD, 1920 x 1080 (2,073,600 pixels)
Native (Pixel-to-Pixel), 16:9, Letterbox, 4:3, 4:3 Narrow,
Letterbox (Anamorphic lens compatible)
All glass, F/2.5~2.71, f = 39.1~50.1mm, 1.3x manual
zoom, made in Japan
1.85 – 2.40 (distance/width) – Standard lens
1.56 – 1.86 (distance/width) – Optional short-throw lens
LS-3:
Down = 25% to 60% of screen height below lens center
(50% to 120% of one half of the screen height)
LS-5:
Up = 25% of screen height above lens center
(50% of one half of the screen height)
Down = 60% of screen height below lens center
(120% of one half of the screen height)
LS-3: None
LS-5: 7.5% of screen width left or right of lens center
(15% of one half of the screen width)
1,000 ANSI lumens (maximum) calibrated at D65
LS-3: 10,000:1 typical
LS-5: 15,000:1 typical
High efficiency adaptive voltage side-to-side cooling
with low system acoustic noise level and low light
pollution cabinet
Front, Rear, Ceiling (front/rear)
User replaceable 180/230W HPM (selectable), 4000
hour lifetime at 180W setting
Runco advanced ViVix processing with 10 bit
independent dual channel image processing, true 1080i
deinterlacing, MPEG artifact reduction (block and
mosquito noise), latest motion adaptive processing, 3D
noise reduction, detail enhancement, rich color
processing and noise reduction, less than one frame
latency
Full RGB gain/offset control (White Balance), Gamma,
Contrast, Color Temperature, Brightness
84 Runco LS-3/LS-5 Installation/Operation Manual