Using The Cloth Guide; Rolled Hem - Janome 1600P series Instruction Book

Using the Cloth Guide

Rolled Hem

q
e
w
q
e
w
r
t
e
y
Attach the cloth guide to the needle plate with the
screw q.
Adjust the position of the cloth guide w and tighten
the screw q.
Place the fabric with its edge e against the cloth
guide and sew.
Attach the hemmer foot w to the presser foot bar.
Tighten the setscrew q using the large screw-
driver.
q Setscrew
w Rolled hem
Fold the edge of the fabric twice, 6 cm (2 3/8˝) in
length and 0.3 cm (1/8˝) in width.
Trim the corner 0.5 cm (3/16˝) r by 0.8 cm (1/4˝) t
for easier insertion of the hem into the foot.
e Wrong side of the fabric
r 0.5 cm (3/16˝)
t 0.8 cm (1/4˝)
y Curl of the foot
Position the fabric aligning the edge of hem with the
curl of the foot y.
Lower the foot and sew 1–2 cm (1/2˝–1˝) while
pulling both threads to the back.
Stop the machine and lower the needle into the
fabric. Raise the foot and insert the folded portion of
the fabric into the curl of the foot.
Lower the foot, and then sew while lifting up the
edge of the fabric to keep it feeding smoothly and
evenly.
18