3
BIIS OPERATION
n Transmitting a call
A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
ï Using call memory
q While in the standby condition, push [P1] (Digital) to enter
the call code memory channel selection mode.
• "
" appears.
C A L L I N G
w Push [Up] or [Down], or rotate [DIAL] to select the desired
call code.
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver
repeats the call 3 times (default) automatically, and
is displayed during each call. However, an error
"WAIT"
beep sounds and
swer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
16
Appears
0 5 0 0
is displayed when no an-
"FAILED"
ï Calling back from the queue channel
q While in the standby condition, push [P1] (Digital) for 1 sec.
to enter the queue memory channel selection mode.
w Push [Up] or [Down] or rotate [DIAL] to select the desired
record.
< Q U E U E >
- Q U E U E ! -
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver
repeats the call 3 times (default) automatically, and
is displayed during each call. However, an error beep
sounds and
is displayed when no answer back
"FAILED"
is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
"WAIT"