I Scan Operation - Icom IC-T7H Instruction Manual

4
ADVANCED FUNCTIONS

I Scan operation

D Full/programmed scan
FULL SCAN
PROGRAMMED SCAN
FULL SCAN: Repeatedly scans all frequencies over an
entire band (the 144 MHz band or the 430(440) MHz band).
PROGRAMMED SCAN: Repeatedly scans between two
user-programmed frequencies. Used for checking for fre-
quencies within a specified range such as repeater output
frequencies, etc. Four pairs of scan edges are available.
18
➀
Push [VFO] to select VFO mode.
➁
Push [ SCAN] for 1 sec.; then, while continuing to
(BAND)
push [ SCAN], rotate the tuning dial to select the
(BAND)
desired scan range.
➥ The following scan ranges are selectable:
• "ALL 144" for full scan on the 144 MHz band.
• "ALL 430" or "ALL 440" for full scan on the 430(440) MHz
band.
• "PROG 1" to "PROG 4" for one of the programmed scans.
➥ After releasing [
(BAND)
➥ To activate the previously selected scan, dial rotation is
not necessary—just push [
➥ During scan, the following can be changed:
• Scan range using [
(BAND)
• Scan direction using [DIAL].
➂
To stop the scan, push [
(VFO)
NOTE: For programmed scan, scan edges must be pro-
grammed in advance (1A/1B are programmed by default).
Program scan edges in the same manner as regular
memory channels (p. 15)
If the same frequencies are programmed into a pair of
scan edges, programmed scan edge flashes, such as
"P1," but programmed scan does not proceed.
SCAN] the selected scan starts.
SCAN] for 1 sec.
(BAND)
SCAN], with/without [DIAL].
CLR].