Advanced Functions; I Memory/Call Channels; Programming During Selection - Icom IC-T7H Instruction Manual

I Memory/call channels

The transceiver has 70 memory channels (60 regular, 4 pairs
of scan edge channels for mixed bands and 1 call channel for
each band). Note that memory channels are not grouped
according to band. In other words, a given memory channel
can be programmed with either a VHF frequency or a UHF
frequency. This is not the case with call channels. Call chan-
nels are band specific.
The following can be programmed into memory/call channels:
• Operating frequency
• Duplex direction with an offset frequency (pgs. 13, 14)
• Subaudible tone encoder or tone squelch ON/OFF with a
tone (CTCSS) frequency (pgs. 21, 22)
• Skip information (p. 20)

ADVANCED FUNCTIONS

D Programming during selection
➀
Push [VFO] to select VFO mode.
➁
Set the desired frequency:
➥ Set
other data,
repeater information, etc. using
set mode if required.
➂
Push [S.MW] momentarily.
• "X" flashes.
• Do not hold [S.MW] for more than 1
sec., otherwise the memory channel
will overwrite the displayed number.
➃
Rotate [DIAL] to select the desired
channel.
• Call channel and scan edge channels,
as well as regular memory channels,
can be programmed in this way.
• If you want to confirm the VFO fre-
quency, push [S.MW] momentarily.
➄
Push [S.MW] for 1 sec. to program.
• "X" stops flashing.
D UP
such as
L OW
D UP
L OW
D UP
L OW
D UP
L OW
4
MR
MR
15