Hunter Fans Installation And Operation Manual page 11

7. Insert and tighten the ground
screw/leadwire assembly into the
small screw hole on one end of
the 2 1/2" pipe.
CAUTION
Make sure that the leadwire as-
sembly is pointing straight up and
away from the pipe.
WARNING
To avoid possible electrical shock,
the ground screw must be tight-
ened securely.
8. Insert the pin into the two holes
in the 2 1/2" pipe so that the
pin is placed evenly in the hole.
9. Insert the threaded end of the
pipe into the flat side of the ball.
10. Align the cutouts in the ball with
the pin and the ground screw
assembly.
41557-01 3/12/2002
11. Slide the ball up the pipe until it
hits the pin.
12. Insert and tighten the position-
ing screw into the ball so that
the head of the screw is placed
on the end of the pipe.
NOTE: Make sure that the ball
is positioned so that it is level or
straight.
CAUTION
Do not overtighten the position-
ing screw as it may cause the ball
to seat improperly, resulting in fan
wobble and the fan hanging
crookedly.
WARNING
Failure to complete the steps
above properly could result in the
fan falling.
Figure 3c - Flush mount pipe assembly
®
11