Assembly - RIDGID R86008 Operator's Manual

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing
List are already assembled to your product when
you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Drill-driver
Auxiliary Handle
Bit
Bag
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
INSTALLING/REMOVING THE AUXILIARY
HANDLE
See Figures 2 - 3, page 13.
The drill is equipped with an auxiliary handle assembly that
can be mounted on either side of the drill for right or left
hand use.
To install the auxiliary handle:
 Turn the handle grip counterclockwise to loosen it and
open the hooks wide enough to fit over the mounting ribs,
behind the torque adjustment ring.
 Place the hooks over the mounting ribs, making sure the
hooks are positioned in the slots as shown.
 Turn the handle clockwise to tighten. Make sure the
handle is secure before beginning operation.
To remove the handle and install it on the opposite side:
 Turn the handle grip counterclockwise to loosen and
remove the handle.
 Reinstall the handle in the desired position.
7 - English