Config[Ure] Examples - HP T6553 D45 Reference Manual

FUP Commands
than %177. When bitcount is 8, COPY displays the character for any byte
with an octal value of %40 or greater.

When bitcount is 7, the ALTKEY key specifier of INFO, DETAIL, and SHOW
displays for any character with an octal value greater than %177. When
bitcount is 8, the ALTKEY key specifier is displayed for all characters with
an octal value greater than %40.

You can switch between the 7-bit and 8-bit display modes during an interactive
FUP session. To reset the display mode, enter another DISPLAYBITS
command at the FUP prompt with the desired mode.

To set defaults for COPY (with a DUMP option), FILES, SUBVOLS, and
LISTLOCKS commands, use CONFIG[URE] REPORTWIDTH:

If the OUT file (or OUT device) record length is less than REPORTWIDTH,
FUP breaks the output records into multiple records (or lines) to fit the file or
device record length.

The output format for all other FUP commands that output information is 80
columns—regardless of the value specified for REPORTWIDTH.

You can specify translation table defaults for COPY, LOAD, and
BUILDKEYRECORDS commands:

If you use the XLATE option but an XLATE table was not specified in the
CONFIGURE command, an error occurs.

If you specify PAD or TRIM characters in a command that uses an XLATE
option, they must be correct for the specified direction. FUP does not try to
adjust them.

Translation occurs only if you use XLATE, XLATEIN, XLATEOUT, EBCDICIN,
or EBCDICOUT options.

An XLATE option overrides the EBCDICIN or EBCDICOUT options if you
specify both on the same command.

CONFIG[URE] Examples


To use CONFIGURE to set the default options for a DUP[LICATE] process:
-CONFIGURE DUP PURGE, SAVEID
-DUP A, B
FILES DUPLICATED:
The first command (CONFIGURE DUP PURGE, SAVEID) declares the
DUP[LICATE] configure options. The second command (DUP A, B) uses the
PURGE and SAVEID options implicitly. Then FUP displays the number of files that
are duplicated (1).
1
File Utility Program (FUP) Reference Manual—523323-014
2-33
CONFIG[URE] Examples