A Rdf Commands Quick Reference; Rdfcom Run Syntax; Rdfcom Commands Quick Reference; Add - HP NonStop RDF J-series RVUs Management Manual

A RDF Commands Quick Reference

The syntax rules for the RDFCOM and RDFSCAN commands, explained in detail in
(page 187) and
written for system managers and operators, summarizes the syntax descriptions for:
• The command to run RDFCOM from the Guardian user interface to the NonStop operating
system. See
• The RDFCOM commands, listed in alphabetical order, beginning with the ADD command.
See "RDFCOM Commands Quick Reference" (page 349)
• The RDFSCAN commands, listed in alphabetical order, beginning with the AT command.
See "RDFSCAN Commands Quick Reference" (page
• The file names and process identifiers that are common parameters in many RDFCOM and
RDFSCAN commands. See

RDFCOM Run Syntax

RDFCOM runs under the Guardian user interface (normally the TACL command interpreter)
to the NonStop operating system. The RDFCOM command starts a session that lets you enter
RDFCOM commands interactively, noninteractively, or through a command file.
Where issued: primary or backup system.
Security: Any user.
RDFCOM [/[IN command-file ] [,OUT output-file ]/
[control-subvolume] ; [command [; command ]...]
For more detailed information about RDFCOM commands, see

RDFCOM Commands Quick Reference

ADD

The ADD command applies configuration parameter values for the specified process or other
object to the RDF configuration file.
Where Issued: Primary system only.
Security: Super-user group member
ADD {RDF
{MONITOR
{EXTRACTOR
{RECEIVER
{IMAGETRAIL $volume
{PURGER
{RDFNET
{NETWORK
{[VOLUME] $volume
{TRIGGER trigger-type }

ALTER

The ALTER command changes the setting of the specified parameter in the RDF configuration
file to the supplied value.
Where Issued: Primary system only except for the Takeover Trigger that can be altered on primary
or backup system.
Security: Super-user group member.
ALTER {RDF
{MONITOR
{EXTRACTOR extractor-option }
Chapter 9 (page 261), are summarized in this appendix. This appendix, which is
"RDFCOM Run Syntax".
"File Names and Process Identifiers" (page
}
}
}
}
}
}
}
}
}
global-option
monitor-option
357).
Chapter 8 (page
}
}
Chapter 8
358).
]
187).
RDFCOM Run Syntax 349