Installation Of Second Unit - Hoshizaki KM-2500SWH3 Instruction Manual

If a Hoshizaki B-1300, B-1500, B-1650, or non-Hoshizaki bin is used:
g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the
thermostat extension bracket (stainless). Use the 2 screws to attach the "Z" bracket
(plastic) to the thermostat extension bracket (stainless).
h. Use the two 4×10 stainless steel screws in the accessory bag to attach the
thermostat bulb attachment (with attached thermostat bulb) to the "Z" bracket.
i. Remove the 2 screws from the lower part of the thermostat bracket (plastic) and use
them to attach the thermostat extension bracket (stainless) to the thermostat bracket
(plastic).
6) Level the icemaker and storage bin in both the left-to-right and front-to-rear directions.
Adjust the storage bin legs to make the icemaker level.
7) Replace the panels and baffle in their correct positions (unless you are installing a
second unit). (See "E. Installation of Second Unit.")
E. Installation of Second Unit
1) See "II.D. Setup" for the lower unit installation.
2) Remove the top panel and the top insulation of the lower unit. The top panel and the
top insulation of the lower unit are not required when installing the second icemaker.
3) Unpack the second icemaker (upper unit), and remove the shipping carton, tape, and
packing material.
4) Remove the panels of the second icemaker.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit using the 2 mounting brackets and the bolts
provided.
Thermostat Bracket
(plastic)
Thermostat Bulb
Attachment (plastic)
Thermostat Extension
Bracket (stainless)
"Z" Bracket (plastic)
Mounting
Brackets
Bolts
11
Fig. 5
Icemaker
(Upper
Unit)
Icemaker
(Lower
Unit)
Fig. 6
Bin