Table of Contents
Advertisement
Contents
Section
General Application Information
The Sump and Installation
If your basement does not currently have a sump installed, it will be necessary to check
local plumbing codes as to the acceptable type of sump that may be used. Materials
commonly specified are: clay tile, fiberglass, steel, concrete, and polyethylene. It may be
necessary to cut a hole in the basement floor and excavate for the sump. Plumbing and
electrical contractors can advise on proper installation of drain tiles, sump, pump, and
electrical service. Honda recommends that a solid sump base be provided. The sump is
fed by drain tile placed around the outside and/or inside basement walls at the footings. In
applications where a gravel base must be used to relieve hydraulic pressure under the
basement floor, be sure to provide a permanent and solid base for the pump (bricks or a
steel plate). A sump cover capable of supporting 200 pounds should be employed to
contain odors and for obvious safety reasons.
Page
3
5
6
6
6
7
8
9
10
11
12
14
15
16
17
18
20
21
22
3
Advertisement
Table of Contents
