Stopping The Engine; Emergency Engine Stopping - Honda Marine BF75A Owner's Manual

OPERATION
6. If the choke and fast idle control(s)
was used to start the engine, return
the control(s) to the normal
operating position as the engine
warms up.
During the warm-up period, check
the oil pressure indicator (p.
overheating indicator (p.
cooling system indicator (p.
7. Leave the recoil starter assembly
off, but install the engine cover (p.
32 ), and lock it in place by
latching the engine cover latch.
Exposed moving parts can
cause injury.
Do not operate the
outboard motor without
the engine cover.
Use extreme care when
installing the engine
cover.
58
8. If it was necessary to remove the
emergency stop switch lanyard
from your wrist to perform the
emergency starting procedure, be
sure the lanyard is attached to your
wrist before operating the
outboard motor.
35 ),
36 ), and 9. Have your closest authorized
37 ). Honda marine dealer check your
electrical system and correct the
problem, so you can use the
electric starter.
The recoil starter assembly (p.
should be reinstalled after the
electric starter is working again.
Install the recoil starter assembly
with the engine stopped.

STOPPING THE ENGINE

Emergency Engine Stopping

Tiller-Handle Type
EMERGENCY STOP SWITCH
57 )
SWITCH CLIP
Side-Mount Type
EMERGENCY STOP SWITCH
SWITCH
CLIP
LANYARD
PULL
LANYARD
PULL