Propeller - Honda Marine BF25A Owner's Manual

Il. MAINTENANCE
Propeller
PROPELLER
COTTER PIN (stainless)
-CASTLE NUT
LAIN WASHER
ARINE GREASE
THRUST WASHER
If the propeller is damaged, replace it
as follows:
Removal:
Remove the
cotter pin then remove the
14 mm castle nut, 15 mm plain washer,
propeller and thrust washer.
COTTER PIN (stainless)
Installation:
Install the thrust washer with the
grooved side toward the gear case, then
install the new propeller in the reverse
sequence of removal.
Hand tighten the castle nut until the 3
mm cotter pin can be installed. If
necessary, tighten the castle nut just
enough to align the hole with the
groove in the nut.
Use a new genuine Honda cotter pin
and bend the cotter pin
ends
as
shown.
84