Motor Attachment - Honda Marine BF25A Owner's Manual

4. INSTALLATION
Motor attachment
STERN
P SCREW
SHERS
BOLG
'NUT
SAFETY ROPE
TRANSOM BOARD
Attach the stem bracket to the transom
and tighten the clamp screws.
j=miq
l
Before operating the boat, check
the tightness of the clamp screws.
l
Tie a rope through the hole in the
stern bracket and secure the other
end of the rope to the boat. This
will prevent accidental loss of the
motor.
To prevent the outboard motor from
falling accidentally, you may further
secure the stem bracket to the transom
board with the optional Mounting Bolt/
Nut Kit. Good quality stainless steel
commercially available bolts, nuts and
washers may also be used.
Before installing the bolts, be sure to
apply sealant to the bolt holes. This
modification should be made by your
authorized Honda Marine or Honda
Outboard Motor dealer.
For battery handling and installation
information refer to pages 76, 77.
25